I`m looking for information on a clutch problem in my 1996 Chevy S10 pickup. The clutch releases too low to the floor. Its supposed to be a self adjusting clutch, and the problem does seem to get b...
Had the same problem once and went nuts trying to figure it out. Finally it turned out the gasket was not the right one and was interfering with the flapper on the thermostat. It was my fault, the t...
Richard,
I don't think you have any problem really. You don't say how old the car is but, with anything other than 'brand new' I don't see any problem w/ how you describe ...
Today, shortly after driving through a large puddle, I noticed a problem with the brakes on my 2000 SE. The pedal felt hard on first application and braking was slow as if the power assist was gone. T...
...o find the right gear. Especially 3 & 4 , I wind up going in 6 instead of 4 & 5 instead of 3. This problem seems to get worse as the miles add up rather then working in. Also hear a clunk but ...
This sounds like the problem.
Thanks,
Marc
...d noticed i cant downgear from 3rd to 2nd gear, but when i go from 1st to 2nd it seems fine. anyone have a problem like this? the shifter just will not go into 2nd when coming from 3rd, but all is fin...
Kelly,
I have never had the problem, but if it happens with more than one tape, it is probably the mechanism that takes the tape and loops it around the playback head. If that is the case, I don...
...to start replacing the remaining parts, first the slave cylinder (cheaper and possibly more likely to have problems), if that doesn't solve the problem, the master...
...e noticed, though, that the top starts to creep up. I thought I remember it staying down. Is this a common problem? Is there something I should do to prevent this? I'd like to avoid putting that ...
"back" to the right after noticing a police car next to you is if you were cruising in the left lane. Doesn`t sound as though you were keeping right except to pass, and doesn`t sound as th...
Iha vve a2003 Buick Park Avenue Ultra and my problem occurs when I accelerate at 60-65 speed. The car rumbles and it is felt and seen inside the car. It is felt in the steering wheel. What is happe...
I have a 2002 Grand Marquis with automatic transmission. The car has the gear shifter up by the stearing wheel. Recently my 5 year old son was screwing around in the car and I believe he did this........
i have a 1991 mazda mx-5 and when i seem to rev the throttle slightly or pat the gas it will make a small miss or hesitation. i have installed a header a jackson racing cold air induction and removed ...
I just got an aftermarket brake handle and button from RSpeed, and was anxious to install it. However, after I removed the stock brake button and the spring from the metal 'stem' thingy, the...
...you can probably also fix it for about the same price. If the motor is working as you say, the most likely problem (and IAC the most common problem for a power antenna) is that the nylon intenal cable...
of hills it will be fine. I use the CC on my GTI for road trips no problem.
The real problem is it is next to useless in everyday driving because there are no highways around here uncongested en...
I had this problem a little while back and went through the process of trying to clear the drain holes...
Only to realize they were clear and I was hearing the gas slosh around in the tank. A fill...
...yone had there 'check engine light' come on. Besides a loose fuel cap or fuse, what could be the problem? End Quote
It could be a whole list of possibilities. How many miles? It should b...
Good luck resolving your shifting problems. Hope my post above helps you resolve them. There are so many people who really enjoy shifting their 6-speeds that I believe the focus should be on what'...
...y day because it would result in a poor finish. This was MANY years ago, so newer paints may not have this problem. Or the guy just wanted to go drinking instead that day. Anyone have any paint knowle...
Hi,
Ever since I bought my 1999 Miata I have had a 'wheel hop' problem. Actually it is more correctly a slip and grip situation. The problem manifests itself in many ways. I have even de...
The back-up lights on my 90 are not working and I suspect it is the switch. I have heard of a possible problem with replacing the switch and causing the transmission to get stuck in reverse. Does any ...
Had problems with ours in our 10AE. Loose shifter bolts. (Bolts that hold the shifter in place.) That's all it was. Slightly lower rpm at highway speeds is really nice. This was an assembly probl...
...nsmission started making wild sounding shrieking noises when putting it in 1st and reverse. Naturally, the problem is getting worse, and spreading to 2nd, and now to third. The tranny is obviously sel...
...t rear went completely. Of all things, it happened to be a Firestone tire! Some of the SUVs seem to have a problem in that the wheel well is the right size to allow a thrown tread to hang up in the wh...
...in the dry and oversteer in the snow. If you`re only doing easy city driving you probably won`t notice a problem in the dry, but you could very easily run into a problem in the snow....
I had quite a bit of problems with Mazda Warranty. I took my car in 4 times with a powertrain vibration (I thought would be easy to fix). They gave me the 'all cars do that' crap, and '...
I have a 1988 GMC Safari that has a dead passenger power window only. The motor is good. The problem is a voltage issue. I figured out that +12 V is for driving the motor to roll the window up and -...
As for the clink problem - it has been fixed, or at least seems to have after a full day of test driving. Mmmm good day. Anyways, on this the fourth visit to the dealer for this problem, I mentioned (...
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its
Terms, Rules & Privacy.
Copyright © 2006 - 2010 Roadsters Way