My ProfileBloggers Wanted
We're looking for people to help with the main blog.If you are consistent, knowledgeable and you're into it, please drop me a note. |
rear
...nd tails wagging because among its many features are several that are particularly dog-friendly.
a rear hatch pet ramp for easy loading and unloading,
a leash tether for securing pets in the v...
...It is based on a 41 year old idea but is nevertheless alive and kicking. The latest evolution of this rear-engined car sports a 3.8-litre engine, providing 261kW of pure angry, malevolent power. T...
Any tips for removing stuck rear brake drums on a `97 Saturn SL? The drums turns freely, so I don`t think they`re hung up on the brake shoes. Rather, they just seem to be rusted to the axle flange.
Can anyone recommend a good book on rear solid axle 3 link suspensions? My buddies roadrace car has this setup, and all they have been able to do is dial themselves into ill-handling oblivion with
With rear wheel drive and the same size tires on the front and back, the rear tires wear faster but I`ve always compensated for that by rotating the tires front to back. With different sized wheels
...r maybe get a 4 door Galaxie and put a 5.0 fuel injected engine and overdrive tranny with a low geared rear end, cats and all the other emissions stuff too. I`ve seen it done and getting better tha...
1964 Intl. Loadstar 1800. What is the correct procedure for tightening the front and rear wheel bearings? I can only assume that they are not supposed to run preloaded. Is this correct? On smaller
...next to completely clueless.
I realized that my trusty/rusty Mazda 626 can fit Graco child seats in rear but cannot do so with seats all the way back. I am nearly 6`3" and one of the main reasons...
...gs given by the shop do not make sense OR they partial sense. They told me that my car did not require rear wheel adjustments.
Left front actual toe=0.05, Left front before toe=-0.15, Specified r...
...AND NEW CLUTCH. MSD IGNITION AND COIL. 24 LB-INJECTOR AND 190 LT. FUEL PUMP. GUAGES-AUTO METER. REAR END 8.8 WITH 3.55 GEARS AND 6 POINT ROLLBAR. LAKEWOOD SUSPENSION. FLOW MASTER MUFFLERS. ...
...hts illuminate, but at the second position when the headlights go on, the front parking lights go out. Rear taillights illuminate at either position.
Bad switch or bad wiring? If switch, where wo...
...it in the Honda Dealership for a brake job 3 weeks ago. The following week, my neihbor backed into the rear side (exhaust side) and creamed the bumper and upper side panel. He offered to pay in cas...
Thought you guys might like to see this wicked CRX I found on eBay. Anyone know where the rear window design is from? It looks awesome! If I had the cash, I`d buy it, but I think it`ll go for at
...people suggest that the distribution valve is bad, but then other people say they never go bad. I have rear wheel abs, but the rear brakes are fine. The rotors are good, too. I made sure I checked ...
...ding pipes and tips). Warranty and value are a concern as well. These pipes will be angled out to the rear corners of the truck and will have 4" chrome tips.
Thanks in advance for the advice....
...t as my play car. HOWEVER, it has many problems, which tell me to throw more money at the Nissan (new rear struts, new rear rotors/pads, maybe rear calipers, new floorpan, new electrical wiring, ne...
...l speeds, different pads or rotors are not going to shorten your one-time stopping distances at all. rear brakes with new stock rotors and Carbotech pads, but didn`t get to the fronts, which will ...
...those four round headlights and a straight-up `Cd-be-damned` grille, not to mention the subtly-curved rear `haunches` that all say `Jaguar` to anyone familiar with the older saloons` designs. Folks...
I notice that those flip-down DVD screens in SUVS are often directly behind the rear-view mirror. They clearly block the driver`s view and create a safety hazard.
Some car stereo decks now have s
...83 mustang.
The brakes started feeling very mushy so I went to bleed them. The bleeder on the left rear was broken off so I decided to replace the rear wheel cylinders. I did that and chaned the...
...mp myself for $40 and my neighborhood wrench took care of the U-joints for sumpthin like $75 each. Had rear pinion seal replaced twice under warranty. I know my luck may be running out.
So, where...
...g it):
"The ratio between the wheelbase and the track (taken as an average between the front an the rear track) seems to be an important parameter that is relevant to handling characteristics of ...
...nt increase from the 1997 level of 693, Federal Highway Administrator Mary Peters said.
Peters said rear-end crashes are the most common type of work-zone crash, and drivers comprise a higher per...
...o shops and carryouts, south of Capitol Heights.
It was there that Phillip Hansberry`s pickup truck rear-ended Clifton Stokes`s Blazer early on a cool Sunday evening. The two men got out, Hansbe...
I have a Ford van thats had a minor dent filled by the rear door with bondo many years ago and was primed and painted afterwards. About a month ago i was rearended now that bondo is cracked and was
The rear seal engine oil sealhas just started leaking badly. The flame trap assembly & hoses are clean and tight and the the oil vapor separator is clean too so I presume that the rear seal is gone
...the term for the goofballs that pull around to pass two cars, dive back in, slam their brakes to avoid rear ending someone and create a chain reaction slowdown?...
...kes applied for a while. Any way to clean it off without removing them? The rotors are fairly new, the rear ones were just put on before last winter`s driving season....
...what he does. I pass him going 75 still.
About 5 miles later, I see another set of headlights in my rearview, alongside Mr. Bacardi`s, they come up on me, I don`t even think twice about it; I`m ...
...x offender for the rest of his life, and this two-time sheriff`s deputy will not be allowed to carry firearms, according to Baker.
Svilich had originally denied the charges, according to court do...
...safe stopping distance.... a vehicle in front of me slowed, I sensed that and applied my brakes. I was rear ended by someone who did not maintain adequate distance, I stopped to make sure everyone ...
I saw a truck the other day that i swear, the rear end had been made to look just like a front end, complete with grill and headlights. I know it`s meant as a joke but it`s also dangerous since when
...ying attention to a situation ahead. With full headlights, my peripheral vision will notice you in my rear view mirror; with no lights, it won`t....
...ng" sounds.
Keep your ski racks on all year round so that you look like a police car in other car`s rear-view mirrors.
If you are a part-time volunteer at a local fire department and have one ...
Weird automotive reality
The new Beetle left out some nostalgia. It doesn`t have a rear engine, quirky handling, or a heater with all the ferocity of an asthmatic mouse panting on the driver`s an
...n instructed to make a right turn at a "mini-roundabout." And several times he had failed to check his rear-view mirror before using a turn signal. before using a turn signal? Mr. Cummins later ex...
guess you never heard of a dipping mirror
...as 80k on it. I struck a pothole at low speed, then heard air leaking from lr shock. Both sides of the rear then sunk down. A few hours later it came back up but when I pushed on rear air escaped f...
...ciated.. If it`s any help there`s a big switch over when pushing on the brakes.. I think it`s when the rear brakes engage. it`ll start slowing down easy and as more pressure is applied to the brake ...
I was rear-ended a week ago - it was a very minor hit (under $700 in damage) but did injure me. However, I am much more susceptible to injury b/c I`ve been injured before (prior rear-ending about a
Any info will be appreciated
I was told that the rear shocks on my sentra are actually struts but they dont look like the front end struts on my car. Any way i was told that they would have to be
..., the perfect vehicle is a small foreign (to the United States, that is) TWO wheel drive car (front or rear) with plenty of power, good handling and a MANUAL transmission. But I`m certainly willing ...
... far as lighting, signalling, mirrors, etc. are concerned, but most of the pictures show the front and rear sidemarkers and other equipment that is required only in North America.
Are GM models w...
...r knee, pretend to be holding a pair of drum sticks, and start beating away at the steering wheel and rear-view mirror. While the whole time bobbing your head all over the place.
If another driv...
...an that).
Nice 15" alloy mags, 3 decent A/S tires (Goodyear Eagle) and one not so decent one on the rear offside. Not quite sure why, but that can easily be dealt with. "Muggins" didn`t speed muc...
...driver, 53-year-old Randall Orrick of Atascadero, sped up to avoid Feng`s overturning SUV but ended up rear-ending a Toyota 4-Runner. Orrick was killed and his passenger, 33-year-old Jose Luis Tole...
I just pulled the rear head off because of leaking coolant at what appeared above the knock sensor . I suspected a cracked head but see no evidence of that but the head gasket was very corroded and
...enault.com/gb/produits/coupe2.htm and click on the Exterior Design shots link on the right column. The rear end of the car should appear in all its "greatness"!...
...autos.driving, Doug Warner said: ; Let`s see, we have all sorts of "aero" stick-on plastic, gigantic rear ; wings on FWD cars that product only drag, exhausts that fart, buzz,
What does the orie...
...ite regarding what you can and can not do with a rifle with the exception of a ban on discharging a firearm within city limits.
Is it legal, in most states, to drive around with the rifle in the...
Page: 12
|
Latest Hot PhotosLatest Posts
|



